Garage Door Sensor Installation Lake Mohegan, NY

Garage Door Sensor Installation Lake Mohegan, NY

Lake Mohegan garage door sensor installation runs through our shop constantly. Set in New York's continental-climate region, these doors meet winter snow and ice load on doors and tracks, wide seasonal swings that work bolts loose over time, and doors frozen to the slab on the coldest mornings, and we choose parts that outlast it.

Lake Mohegan, NY is shaped by a humid continental climate — hot, humid summers and cold, snowy winters, with sharp freeze-thaw swings between seasons. We've learned which parts last in New York's continental-climate region, because winter snow and ice load on doors and tracks, wide seasonal swings that work bolts loose over time, and doors frozen to the slab on the coldest mornings take a steady toll on springs, tracks, and seals.

Nine out of ten Lake Mohegan calls trace back to rusted hardware from snowmelt and road salt, freeze-thaw-cracked bottom seals, doors frozen to the slab on cold mornings, and humidity-swollen wood doors in summer. We pinpoint which one it is before quoting a cent.

Photo-eye safety sensors are required by UL-325 on every garage door opener manufactured since 1993. They detect obstructions in the door's path and either reverse the door (during close) or refuse to start (when activated). When sensors are misaligned, dirty, sun-blinded, or failed, the door either refuses to close at all or — worse — closes without sensing an obstruction. Our sensor installation service replaces failed sensors, realigns drifted brackets, cleans the eye optics, and verifies auto-reverse on a real obstruction test.

Replacement eyes are brand-specific (LiftMaster has a different connector and signal pattern than Genie). We stock the major brands and most legacy models. Brackets occasionally need replacement when corrosion has degraded them or impact has bent them. Bracket alignment is critical — eyes that are slightly off-aim trigger intermittent close failures that drive homeowners crazy.

Every visit ends with an obstruction test: a 1.5-inch (3.8 cm) tall object placed under the door at three positions across the opening. The door must reverse when it touches the object. This is the UL-325 baseline — if the door doesn't pass, the install isn't complete. We document the test results on the work order.

Signs you need garage door sensor installation